SP510E Ultra High Speed Multiprotocol Transceiver
The SP510E is a highly integrated physical layer solution that is configurable to support multiple serial standards. It incorporates eight drivers and eight receivers (8TX/8RX), configurable for either differential (V.11 or V.35) or single ended (V.28 and V.10) signaling. SP510E enables a Serial Communications Controller to implement a variety of serial port types including V.24, V.25, V.36, EIA-530, EIA-530-A, X.21, RS-232. The device architecture is designed to support the data and clock signals used in HDLC or SDLC serial ports as either DTE or DCE. Operating configuration is programmable in system using the mode-select pins. The V.11 and V.35 modes include internal bus termination that may be switched in or out using the TERM_OFF pin. The SP510E is ideal for space constrained applications. It requires only a single 5V supply for full operation. The VL pin determines the receiver output voltage (VOH, down to 1.65V), for interfacing with lower voltage CPUs and FPGAs. For single supply operation at 5V the VL pin will be connected to VCC. Fully compliant V.28 and V.10 driver output voltages are generated using the onboard charge pump. Special power sequencing is not required during system startup. Charge pump outputs are internally regulated to minimize power consumption. The SP510E requires only four 1µF capacitors for complete functionality. The device may be put into a low power shutdown mode when not in active use.
| 应用技术支持与电子电路设计开发资源下载 | 版本信息 | 大小 |
| SP510E 数据资料DataSheet下载:pdf | Rev.V2 | 2 页 |
