TPS54262-Q1 具有低 IQ、电压监控和复位功能的汽车类 2A、60V 降压 DC/DC 转换器

TPS54262-Q1 描述

The TPS54262 is a step-down switch-mode power supply with a voltage supervisor and an integrated NMOS switching FET. Integrated input voltage line feed forward topology improves line transient regulation of the voltage mode buck regulator. The regulator has a cycle-by-cycle current limit. The device also features low-power mode operation under light load conditions which reduces the supply current to 50 µA (typical). By pulling the EN pin low, the supply shutdown current is reduced to 1 µA (typical).

An open drain reset signal indicates when the nominal output drops below the reset threshold set by an external resistor divider network. The output voltage start up ramp is controlled by a soft start capacitor.

TPS54162-Q1 TPS54262-Q1 TPS54362-Q1
Iout(Max)(A) 1   2   3  
Vin(Min)(V) 3.6   3.6   3.6  
Vin(Max)(V) 60   60   60  
Vout(Min)(V) 0.9   0.9   0.9  
Vout(Max)(V) 18   18   18  
Iq(Typ)(mA) 0.05   0.05   0.065  
Switching Frequency(Max)(kHz) 2200   2200   2200  
Switch Current Limit(Typ)(A) 2.15   3.2   6  
Topology Buck   Buck   Buck  
Operating Temperature Range(°C) -40 to 125   -40 to 125   -40 to 125  
Pin/Package 20HTSSOP   20HTSSOP   20HTSSOP  
Rating Automotive   Automotive   Automotive  
Regulated Outputs(#)   1   1  
Thermal Shutdown Yes   Yes   Yes
TPS54262-Q1 特性
TPS54262-Q1 芯片订购指南
器件 状态 温度 (oC) 价格(美元) 封装 | 引脚 封装数量 | 封装载体 丝印标记
TPS54262QPWPRQ1 ACTIVE -40 to 125 2.65 | 1ku HTSSOP (PWP) | 20 2000 | LARGE T&R 54262Q1
TPS54262-Q1 质量与无铅数据
器件 环保计划* 铅/焊球涂层 MSL 等级/回流焊峰 环保信息与无铅 (Pb-free) DPPM / MTBF / FIT 率
TPS54262QPWPRQ1 Green (RoHS & no Sb/Br)  CU NIPDAU  Level-1-260C-UNLIM   TPS54262QPWPRQ1
TPS54262-Q1 应用技术支持与电子电路设计开发资源下载
  1. TPS54262-Q1 数据资料 dataSheet 下载.PDF
  2. TI 德州仪器非隔离式开关 DC/DC 调节器选型与价格参考 . xls
  3. Dual MOSFET Driver (PDF  498 KB)
  4. 全面认识开关型电源中的BUCK-BOOST功率级 (Rev. A)   (PDF  2206 KB)
  5. Understanding Boost Power Stages In Switchmode Power Supplies   (PDF  149 KB)
  6. Understanding Buck Power Stages In Switchmode Power Supplies   (PDF  173 KB)
  7. 标准线性产品交叉参考 (Rev. D)   (PDF  1058 KB)
  8. 模数规格和性能特性术语表 (Rev. A) (PDF 1993 KB)
  9. 所选封装材料的热学和电学性质 (PDF 645 KB)
  10. 高速数据转换 (PDF 1967 KB)