STA1052:CD-MP3 audio SOC

The STA1052 is a single chip device which performs all functions related to read back of optical disk: servo control operations, reading optical disc decoding the High frequency signals, EFM decoding, error correction, software decoding of MP3 and WMA encoded audio, sample rate conversion, managing file system, serial transfer of audio/program through I2S/SPDIF, direct playback of audio through in-built audio DAC.

It also performs software decoding of MP3, AAC and WMA encoded audio from USB or SD card™ memory supports.

Commands can be exchanged with the Host MCU either via one I2C port or two SPI ports.

STA1052 chip comes along a broad software suite that comprehends different types of compressed audio files, File System Management, Play Lists.

The key Media and File Types supported are briefly reported below:

- Ability to play any USB/SD card compatible solid state memory media

- MPEG1-Layer 2 compressed audio files

- Playback of MP3 compressed audio files (all bit rates and VBR)

- Playback of lower bit rate MPEG2 layer 3 files and MPEG-2.5 extension

- Playback of WMA version 9 compressed audio files

- Playback of iTunes AAC compressed audio files

- Sample rate converter for recorded sampling rates other than 44.1kHz

- Support FAT16/FAT32 file systems

- Support ISO9660 and Joliet file systems

The software can manage the following File Information: folder and file names.

ID3 tag information - as per versions 1.0-1.1, 2.0 - 2.4 - is reported. Further parameters made available by ST software are: File type (i.e. .mp3, .wav, .wma, .cda, .aac), Bit rate, entire file path for current track and track elapsed time.

STA1052 software provides the essential Navigation Commands: Previous/Next , Fast forward/Rewind, Jump to any file, Scan, Pause. All these commands can be programmed and configured via Command Protocol Interface.

Two different types of Playlists are supported: Playlists with .pls extension, Playlists with .m3u extension.

Robust software architecture provides an efficient error handling and related messaging.

ST developed a software architecture that allows the patching of a few parts of software resident in ROM. Software patches are loaded into a very inexpensive serial Flash which provides the capability to patch up to 40 KByte of ROM software.

Software build (patching) upgrade from media USB and SD card and from host MCU onto serial Flash is supported.

STA1052 is intended for use in automotive entertainment system.

Key Features

  • Operating temperature range: -40 °C to +85 °C
  • 33.8688 MHz external quartz/resonator
  • Analog Front-end partA, B, C, D, E, F voltage inputsAutomatic gain and offset controlALPC circuit with integrated Power MOS8 bit 2 channels general purpose ADC
  • Embedded ARM7TDMI microcontroller32 bit MCU with 3-stage pipeline @ 67 MHz384 KB internal ROM (4 Mb on package RAM for development version) and 128 KB RAMI2C master/slave (400 kHz) + 1 CRQ lineTwo high-speed UART full-duplexTwo buffered SPI master/slave interface
  • AcquisitionFull range adjustment-free digital PLLEFM demodulation and synchronizationQ subcode and CD text decoder
  • Digital servoAutomatic fine gain/balance/offset adjustment for tracking and focusEmbedded 16 bit servo DSP (33.8688 MHz)PDM controls for focus, tracking, spindle, sledgeEmbedded stepping sledge motor controllerCLV & CAV spindle control
  • Shock-proof controllerUp to 64 Mbit external SDRAM interface8/16 bit data bus interfaceADPCM (4:1) lossy compression for extended shock proof capability
  • Error correctionCIRC, capable of dual C1, quad C2 erasureRSPC capable of C3 correctionsJitter absorbing capacity ±24 frames (CLV)
  • Audio featuresTwo I2S transmitters and one I2S receiverSPDIF transmitter (IEC958) and receiverSample-rate conversion from 8 kHz - 48 kHz input to 44.1 kHz outputDigital equalizer for bass/treble controlBuilt-in stereo DAC
  • IDLE, WFI and STOP modes
  • 1.8 V ±5 % operating supply range for logic
  • CD-R, CD-RW playback
  • CLV (1x, 2x, 4x) and CAV mode (6x)
  • Audio decoding (MP3,WMA,AAC)
  • 3.3 V ±5 % operating supply range for I/O
  • Power on reset / Brownout controller
  • On-chip USB-OTG host full speed
  • Development environment5 pin JTAG port (IEEE 1149.1 standard)
产品规格
DescriptionVersionSize
DB0582: DSP/MCU system for CD-DA, CD-CA, CD-ROM player2.0204 KB
样片和购买
型号PackagePacking TypeOperating Temperature (°C) (min)Operating Temperature (°C) (max)Unit Price (US$) *QuantityECCN (EU)ECCN (US)Country of Origin
STA1052S1LQFP 144 20x20x1.4Tray-4085--NEC3A991A2MALTA
质量和可靠性
型号PackageGradeRoHS Compliance GradeMaterial Declaration**
STA1052S1LQFP 144 20x20x1.4AutomotiveEcopack2
circuit_diagram_14526_thumbnail.png STA1052
DSP/MCU system for CD-DA, CD-CA, CD-ROM player STA1052