• 简体中文
• English

ADT6502 Low Cost, 2.7 V to 5.5 V, Micropower Temperature Switch in SOT-23 (Monitors Temps from +35°C to +115°C)

The ADT6501/ADT6502/ADT6503/ADT6504 are trip point temperature switches available in a 5-lead SOT-23 package. Each part contains an internal band gap temperature sensor for local temperature sensing. When the temperature crosses the trip point setting, the logic output is activated. The ADT6501/ ADT6503 logic output is active low and open-drain. The ADT6502/ADT6504 logic output is active high and push-pull. The temperature is digitized to a resolution of 0.125°C (11-bit). The factory trip point settings are 10°C apart starting from −45°C to +15°C for the cold threshold models and from +35°C to +115°C for the hot threshold models. Σ-Δ based temperature measurement gives high accuracy and noise immunity. Wide operating temperature range from −55°C to +125°C. ±0.5°C typical accuracy from −45°C to +115°C. Factory threshold settings from 35°C to 115°C in 10°C increments. Supply voltage is 2.7 V to 5.5 V. Supply current of 30 μA. Space-saving, 5-lead SOT-23 package. Pin-selectable temperature hysteresis of 2°C or 10°C. Temperature resolution of 0.125°C. Medical equipment Automotive Cell phones Hard disk drives Personal computers Electronic test equipment Domestic appliances Process controls

These devices require no external components and typically consume 30 μA supply current. Hysteresis is pin-selectable at 2°C and 10°C. The temperature switch is specified to operate over the supply range of 2.7 V to 5.5 V.

The ADT6501 and ADT6502 are used for monitoring temperatures from +35°C to +115°C only. Therefore, the logic output pin becomes active when the temperature goes higher than the selected trip point temperature.

The ADT6503 and ADT6504 are used for monitoring temperatures from −45°C to +15°C only. Therefore, the logic output pin becomes active when the temperature goes lower than the selected trip point temperature.

Product Highlights

• Σ-Δ based temperature measurement gives high accuracy and noise immunity.
• Wide operating temperature range from −55°C to +125°C.
• ±0.5°C typical accuracy from −45°C to +115°C.
• Factory threshold settings from 35°C to 115°C in 10°C increments.
• Supply voltage is 2.7 V to 5.5 V.
• Supply current of 30 μA.
• Space-saving, 5-lead SOT-23 package.
• Pin-selectable temperature hysteresis of 2°C or 10°C.
• Temperature resolution of 0.125°C.

Data Sheet, Rev. A, 1/08

Data Sheets

Order Information