MAX3420EEVKIT-2：Evaluation Kit for the MAX3420E
The MAX3420E evaluation kit-2 (EV kit-2) provides a
proven design to evaluate the MAX3420E USB peripheral
controller with SPI™ interface. The EV kit-2
board is jumper-connected to an Atmel® ATtiny2313
microcontroller by default, but can also be connected
to any SPI master. The MAX3420E EV kit-2 adds USB
functionality to any microcontroller, microprocessor,
DSP, CPLD, FPGA, or ASIC with an SPI master interface
or five GPIO lines can connect to the MAX3420E
EV kit-2.
The EV kit-2 board comes with the MAX3420EECJ+
installed.
Key Features- Complies with USB 2.0 (Full Speed)
- Custom USB Drivers Not Required
- USB Powered
- USB Power LED Indicator
- USB Cable Included
- On-Board ATtiny2313 Microcontroller
- Four GPI Port-Connected Pushbuttons
- Four GPO Port LED Indicators
- 20-Pin Signal Header to Connect the MAX3420E
to Any Microcontroller
- Proven PCB Layout
- Fully Assembled and Tested
| Applications/Uses- Cameras
- Cell Phones
- Custom USB Devices
- Desktop Routers
- Instrumentation
- Microprocessors and DSPs
- MP3 Players
- PC Peripherals
- PDAs
- PLCs
- Set-Top Boxes
|
DataSheet
Ordering Information
| Part Number | Status | Recommended Replacement | Package |
|---|
| MAX3420EEVKIT-2+ | Active | | EVKIT; |
