• 简体中文
• English

MAX9129：Quad Bus LVDS Driver with Flow-Through Pinout

The MAX9129 is a quad bus low-voltage differential signaling (BLVDS) driver with flow-through pinout. This device is designed to drive a heavily loaded multipoint bus with controlled transition times (1ns 0% to 100% minimum) for reduced reflections. The MAX9129 accepts four LVTTL/LVCMOS input levels and translates them to output levels of 250mV to 450mV (standard LVDS levels) into a 27Ω load at speeds up to 200Mbps (100MHz). The power-on reset ensures that all four outputs are disabled and high impedance during power up and power down. The outputs can be set to high impedance by two enable inputs, EN and active-low EN, thus dropping the device to a low-power state of 11mW. The enables are common to all four drivers. The flow-through pinout simplifies PC board layout and reduces crosstalk by keeping the LVTTL/LVCMOS inputs and BLVDS outputs separated. The MAX9129 operates from a single +3.3V supply and is specified for operation from -40°C to +85°C. It is available in 16-pin QFN and TSSOP packages. Refer to the MAX9121 data sheet for a quad LVDS line receiver with flow-through pinout.

Key Features Drive LVDS Levels into a 27Ω Load 1ns (0% to 100%) Minimum Transition Time Reduces Reflections Guaranteed 200Mbps (100MHz) Data Rate Enable Pins for High-Impedance Output High-Impedance Outputs when Powered Off Glitch-Free Power-Up and Power-Down Hot Swappable Flow-Through Pinout Available in Tiny QFN Package (50% Smaller than TSSOP) Single +3.3V Supply

MAX9129: Typical Applications Circuit Applications/Uses Add/Drop Multiplexers Backplane and Interconnect Applications Cell Phone Base Stations Clock/Data Distribution Digital Cross-Connects DSLAM Network Routers and Switches

DataSheet

Parametrics

Quality and Environmental Data

• MAX9129.pdf

Ordering Information