AMIS-41683: CAN Transceiver, Fault Tolerant , 3.3 V

The new AMIS-41682 and AMIS-41683 are interfaces between the protocol controller and the physical wires of the bus lines in a control area network (CAN). AMIS-41683 is identical to the AMIS-41682 but has a true 3.3V digital interface to the CAN controller. The device provides differential transmit capability but will switch in error conditions to a single-wire transmitter and or receiver. Initially it will be used for low speed applications, up to 125kBaud, in passenger cars.Both AMIS-41682 and AMIS-41683 are implemented in I2T100 technology enabling both high-voltage analog circuitry and digital functionality to co-exist on the same chip.These products consolidate the expertise of ON Semiconductor for in-car multiples transceivers and support together with 0REMX-002-XTP (VAN), AMIS-30660 and AMIS-30663 (CAN high speed) and AMIS-30600 (LIN) another widely used physical layer.

特性
  • Fully compatible with ISO11898-3 standard
  • Very low electromagnetic emission (EME)
  • Fully integrated receiver filters
  • Permanent monitoring of transmit data input
  • High electromagnetic susceptibility (EMS) in normal- and low-power modes
  • True 3.3V digital I/O interface to CAN controller
  • In the event of bus failure, automatic switching to single-wire mode
  • The device will automatically reset to differential mode if the bus failure
  • During failure modes there is full wake-up capability
  • Un-powered nodes do not disturb bus lines
  • Bus errors and thermal shutdown activation is flagged on ERRB pin
  • Short circuit proof to battery and ground
  • Thermal protection
  • The bus lines are protected against transients in an automotive environment
  • Support for low power modes
  • Low current sleep and standby mode
  • Power-on flag on the output
  • Two-edge sensitive wake-up input signal via pin WAKEB
应用
  • In-Vehicle Networking
终端产品
  • Automobiles
培训教材 (1)
Document TitleDocument ID/SizeRevisionRevision Date
Basics of IVN ProtocolsTND6015/D (1165kB)1Jun, 2014
数据表 (1)
Document TitleDocument ID/SizeRevisionRevision Date
Fault Tolerant CAN Transceivers (AMIS-41682 and AMIS-41683)AMIS-41682/D (213kB)9
应用注释 (9)
Document TitleDocument ID/SizeRevisionRevision Date
125 kbps with AMIS-4168xAND8365/D (2060.0kB)0
AMIS-4168x Behavior in Un-Powered ConditionAND8367/D (94.0kB)0
AMIS-4168x Fault Tolerant CAN TransceiverAND8368/D (324.0kB)0
Circuit Configuration Options for TVS DevicesAND8231/D (146.0kB)0
Design Considerations Using CAN Low Speed Fault TolerantAND8366/D (169.0kB)0
Differences between 5V and 3.3V Versions of AMIS-4168xAND8369/D (122.0kB)2
EMI/ESD Protection Solutions for the CAN BusAND8169/D (91kB)2Jun, 2014
System Level Surge Suppression Solutions for the CAN BusAND8253/D (270.0kB)0
TVS Diode Selection Guidelines for the CAN BusAND8181/D (75.0kB)0
封装图纸 (1)
Document TitleDocument ID/SizeRevision
SOIC-14751AP (38.0kB)B
产品订购型号
产品状况Compliance封装MSL*容器预算价格 (1千个数量的单价)
AMIS41683CANN1GLast ShipmentsAEC Qualified PPAP Capable Pb-free Halide freeSOIC-14751AP2Tray JEDEC55
AMIS41683CANN1RGActiveAEC Qualified PPAP Capable Pb-free Halide freeSOIC-14751AP2Tape and Reel3000联系BDTIC
订购产品技术参数
ProductData Transmission StandardData RateNumber of DriversNumber of ReceiversVCC Min (V)VCC Max (V)tPLH Max (µs)IO Max (µA)IIH Max (mA)
AMIS41683CANN1RGCAN114.755.258450006.3
Fault Tolerant CAN Transceivers (AMIS-41682 and AMIS-41683) (213kB) AMIS-41683
Basics of IVN Protocols NCV7441
125 kbps with AMIS-4168x AMIS-41683
AMIS-4168x Behavior in Un-Powered Condition AMIS-41683
AMIS-4168x Fault Tolerant CAN Transceiver AMIS-41683
Circuit Configuration Options for TVS Devices NCV7462
Design Considerations Using CAN Low Speed Fault Tolerant AMIS-41683
Differences between 5V and 3.3V Versions of AMIS-4168x AMIS-41683
EMI/ESD Protection Solutions for the CAN Bus NCV7462
System Level Surge Suppression Solutions for the CAN Bus NUP2105
TVS Diode Selection Guidelines for the CAN Bus NUP2105
SOIC-14 NCV7441
AMIS-41683